Viewing Enclosure Properties

From the Other Hardware tab, under Enclosures, select an enclosure to view its properties.

The following figure and table describe the enclosure basic and advanced properties.

If you have selected multiple virtual drives or multiple physical drives, you have to click on the (Expand button) to perform actions such as starting a a consistency check and so on. This is applicable for all the scenarios where you have selected multiple virtual drives or multiple physical drives and performing certain actions through the Actions dialog.

Table 11. Enclosure Properties

Property	Description	MegaRAID	iMegaRAID	Software RAID	Integrated RAID	Initiator-Target
Vendor ID	The vendor-assigned ID number of the enclosure.	Yes	Yes	No	Yes	Yes
Enclosure ID	The ID of the enclosure in which the drive is located.	Yes	Yes	No	Yes	Yes
Enclosure Type	Type of the enclosure.	Yes	Yes	No	Yes	Yes
Serial Number	The serial number of the enclosure.	Yes	Yes	No	Yes	Yes
Enclosure Model	The enclosure model.	Yes	Yes	No	Yes	Yes
Enclosure Location	Indicates whether the drive is attached to an internal connector or an external connector of the enclosure.	Yes	Yes	No	Yes	Yes
Enclosure Connector	Indicates the connector name and size of wide port. Single Path: [Port 0-3 ×4] - Single ×4 Multipath: [Port 0-3 ×4] & [Port 4-7 ×4]- two ×4 Wide ports: [Port 0-3 & Port 4-7 ×8]- Single ×8 wide port Single Drive [Port 0-3 x1]	Yes	Yes	No	No	No
Revision Level	The revision level of the enclosure's firmware.	Yes	Yes	No	Yes	Yes
No of Slots	Total number of available slots.	Yes	Yes	No	Yes	Yes
No of Fans	Total number of fans that are connected.	Yes	Yes	No	Yes	Yes
No of Temperature Sensors	Total number of temperature sensors that are connected.	Yes	Yes	No	Yes	Yes
No of Power Supplies	Total number of power supplies that are connected.	Yes	Yes	No	Yes	Yes
No of Voltage Sensors	Total number of voltage sensors that are connected.	Yes	Yes	No	Yes	Yes