3.14.3 Backup With LSMT

3.15 Remove HPFS386 Access Controls

If migrating from a HPFS386 system, the HPFS386 access controls should be removed from all HPFS386-formatted drives. If you had installed and disabled Local Security, you already used PREPACL in Section 3.11 Remove Local Security to remove the ACLs on your boot drive.

The PREPACL utility backs up, removes, and, after the migration, restores all HPFS386 Access Control Profiles applied to any subdirectories or files specified as a parameter. Be careful, since PREPACL removes the ACLs and copies backup information to an ASCII file. Careless repetitive usage of this utility will overwrite previous file contents, and the ACLs will be completely lost.

As can be seen in Figure 15 below, the PREPACL utility accepts many parameters.



Figure 15: Syntax of the PREPACL Utility

The following syntax diagram shows only the necessary parameters we used to perform this step:

The syntax for PREPACL is
PREPACL /P /B:<filename> /D:<dirname>

where:

/P

Removes 386 HPFS access control profiles in preparation for OS/2 installation.

/B:<filename>

When removing access control profiles, specifies a file name in which to save the access control profiles. If this parameter is not used, /N must be specified.

/D:<dirname>

Specifies a single subdirectory from which to remove access control profiles.

In the following example, we used PREPACL to remove the ACLs from the F: drive and save them to a file F:\DISKF.ACL.


Figure 16: Backing Up and Removing ACLs with PREPACL

3.16 Boot-Time Considerations