
          Initio 9100/9100W Device Driver(V1.17) for Netware 3.1x, 4.x
	  -------------------------------------------------------------

I)  Installation procedures for INI-9100/9100W Netware 3.1x, 4.x device driver:

    1)  Do the normal netware installation, type
	:load install
    2)	Follow the netware installation manual to Load disk driver from
	floppy.
    3)	For Netware 3.1x
		select directory A:\NETWARE\V_31X
	For Netware 4.0x or later
		select directory A:\NETWARE\V_4X
	For Netware HAM driver
		select directory A:\NETWARE\HAM		(V2.05)
 
II) Driver configuration options:

    /V		Verbose mode provides detail information about driver when
		driver is inititalized
    /!V		Non Verbose mode (default)
    /L		Drvier assumes that all targets have more than one LUN
    /!L		Driver assumes that all targets only have LUN 0 (default)
    /Q:x	Specifies maximum number of tag commands per target
    /!Q		No tag command
    /B:(d,dd),.	Scan device only on PCI BUS x, DEVICE yy
    /B:d	Scan all the devices on the PCI BUS x
    /T:xxxx	Target enable mask WORD (Default scan all targets)
    /WR		Hardware read after write verify
    /!WR	No read after write verify
    /R		Support removable media (default)
    /!R		No support removable media
    /D		Enable support fixed disk drive (default)
    /!D		Disable support fixed disk drive
