
        ********* Firmware Version 3.93 release note *********
                                                     Date:12/03/91

Bug Corrected :

    - Correct Fax image overwritten problem in V.17 mode.

    - Correct scan time problem in AT+FDIS command.

    - Correct temperature defect problem.

    - Correct fax 7200bps speed report problem in class 2 command set.

    - Correct Break handling problem.

    - Correct the compatability problem with the fax 1-212-566-1424.

    - Correct the problem of ';' character in class 2 command set.


Function Updated :

    - It is no need for DTE to add a delay time before sending class 2
      commnad to DCE after 'OK' is received.

    - Add AT+FDCC? command.

    - Add the following features for Next Computer, by set bit 3 of s38:

         . CD turns on 250 ms before 1'st message sent to DTE and turns
           off after all messages is sent to DTE.

         . send 'CONNECT FAX' to DTE before '+FCON' in receiving fax.

         . use S18 to control DTE rate in answering call.

         . Use ASCII characters in +FHNG response, instead of neumerical code.

         . Bisync protocol is always adopted in fax receiving data.

    - &D3, anytime lower DTR will cause modem on hook and load profile 0.

    - If bit 0 of S38 was set to 1, modem will repeat dialing default number
      utill the connection is made. Press any key from keyboard or panel
      (U-1496S) during dialing or handshaking will abort this function.

    - For U1496S, panel lock will not lock screen moving anymore but it will
      inhibit parameters change.

