Digital Equipment Corporation

           KZPSA PCI-SCSI Miniport Driver for Windows NT

                        Version	1.20     

                       June 20, 1995


* This driver is intended to run with Windows NT Version 3.5.  It 
     has been tested on Alpha AXP systems.

* To facilitate tracking driver revisions, OEMSETUP.INF creates a driver 
     revision subentry in the "DECKZPSX" driver key in the registry.
     To take advantage of this revision tracking feature on a system which 
     already has an older version of DECKZPSX, under "add entry"
     procedure, always specify "other" even though an entry for 
     the KZPSA will show up in the list of known devices.
    
* The floppy diskette should have the following files:
  
    TXTSETUP.OEM Driver installation script used during initial 
       Windows NT load

    OEMSETUP.INF Driver installation script for Windows NT Setup
       program

    DECKZPSX.SYS Windows NT Version 3.5 miniport driver for the 
       KZPSA Fast, Wide Differential SCSI adapter.  

    README.TXT This file

    DECSCSI A tagfile used by the setup procedure to insure the
       correct floppy is installed before copying files

 
* To install this driver during an installation of Windows NT: 

    1. Start the Windows NT installation process appropriate for your
       system
    2. Select "Custom Setup"
    3. Enter "S" to configure additional SCSI adapters and select 
       "Other"
    4. Insert the software diskette you created and press ENTER
    5. Select the DECKZPSX driver that matches your version of NT and 
       press ENTER
    6. Continue with standard installation procedure


* To install the driver if Windows NT is already running:

    1. Select "Windows NT Setup" from Main program group
    2. Select "Options" from Windows NT Setup window
    3. Select "Add/Remove SCSI Adapter" from menu
    4. Select "Add" from SCSI Adapter Setup window
    5. Select "Other" from the list of supported adapters
    6. Insert software diskette you created
    7. Enter "A:\" for path to NT driver and select "OK"
    8. Choose DECKZSX driver that matches your version of NT and 
       select "OK"
    9. Select "Install" followed by "Continue" to install the driver


* After installing the KZPSA miniport driver and rebooting Windows 
       NT, SCSI disk and CD-ROM devices will be automatically 
       configured by NT.


* To install Windows NT drivers for supporting SCSI tape devices:

    1. Select "Windows NT Setup" from Main program group
    2. Select "Options" from Windows NT Setup window
    3. Select "Add/Remove Tape Devices" from menu
    4. Select "Add" from Tape Device Setup window
    5. Select desired tape driver from the list of supported tape 
       devices
    6. Select "Install"
    7. Insert Windows NT CD-ROM and enter device letter and path to 
       the Windows NT installation files ("D:\Alpha")


* The KZPSA adapter is not supported by system console firmware as 
       part of the system boot path.  It is not possible to install 
       Windows NT to, or boot from a hard disk connected to the KZPSA.